英文spring rate是什麼意思

spring rate是回彈率，可能大家會覺得比較陌生。在瞭解spring rate意思的同時，還要懂得如何運用才行。那麼現在就一起學習spring rate的英語知識吧。

　　spring rate的意思

回彈率

英 [spriŋ reit] 美 [sprɪŋ ret]

彈簧剛度;彈簧比率;大潮流速;彈簧剛性係數

參考例句：

1. For a 2 spring design (using 2 springs in parallel), each spring rate furnishes half of the rate or 22/2=11 lbs/in.

為2彈簧設計(使用2個彈簧在平行) ，每年春季率提供了一半的比率或22 / 2 = 11磅/在。

2. For a 2 spring design (using 2 springs in parallel), each spring rate furnishes half of the rate or 22/2=11 lbs/in.

為2彈簧設計(使用2個彈簧在平行) ，每年春季率提供了一半的比率或22 / 2 = 11磅/在。

3. This form of gasket has good performance of temperature, low leakage rate, high compression spring rate.

該形式的墊片具有耐温性能好、泄漏率低壓 縮回彈率高的特點。

　　spring rate的網絡釋義

coiled spring coil spring disc spring disk spring spiral spring

盤簧;

spring rate

大潮流速; 彈簧剛度; 彈簧彈性[變化率; 彈簧率;

Front Spring Rate

前彈簧剛性;

variable rate spring

可變剛性係數彈簧; 變率彈簧;

dual-rate spring

可變剛性彈簧;

　　spring rate的'雙語例句

The specimen spring rate increases, thus making it necessary to increase the mass size enormously to provide valid test results.

試樣的彈簧率也增加，因此必需大大地增加質量，以提供有效的試驗結果。

This timing is affected by the relationship among poppet weight, spring rate, poppet travel distance, plunger speed, and plunger diameter.

定時受提升閥重量，彈簧振頻，提升閥閥程，活塞速度以及活塞直徑的影響。

Tolerance of spring opening and that of spring rate have been solved for motor vehicle leaf spring by applying theory of probability, and principal factors effecting these tolerances analysed.

應用概率理論求解了汽車鋼板彈簧的弧高和剛度公差，並對影響這些公差的主要因素進行了分析。

In this paper, the laminated spring rate and stresses of leaves are calculated with the principle of complementary energy and obstacle iteration, taking the mounting conditions of the spring into consideration.

本文應用餘能原理和障礙迭代法求解板簧的剛度和應力，計算會考慮了上壓板長度，下支承長度以及騎馬螺栓預緊力矩的影響。

It introduces the treatment principle and scheme, and does analysis calculation to the raft plate settlement and the spring rate of bottom soil, pile top settlement and the rigidity of pile body, foundation strength, which will supply reference to the similar projects.

介紹了基礎的處理原則及處理方案，並對筏板的沉降及其底土的彈簧剛度、樁頂沉降及樁身剛度、地基強度進行了分析計算，以供類似工程參考。

At the same time it is also pointed out that to increase water jet speed and prolong its affective jet time mainly depend on the accretion of spring rate ( constant) of stiffness and the diminution of plunger cross section area respectively.

同時指出主要通過增大彈簧剛度(常數)和減小柱塞面積來提高噴水速度及增長有效噴水時間。

The reasonable selections of modifying coefficients of spring rate, stress and thickness of last leaf are given when the common curvature method is used.

本文還給出了用共同曲率法計算時，板簧剛度末片應力修正係數的合理取值以及為降低末片應力對其片厚的選擇。

Analysis of the Changeable Spring Rate and Stress for the Ring-wave Spring Membrane Valve

環狀波形閥簧的變剛性及應力分析

Then, by applying a method of successive searching approximation, all the forces loaded on each leaf, and the stresses, deflection curve and spring rate of each leaf can be worked out.

採用一種逐步搜索逼近法，可解出各個接觸點的位置及作用力的大小，並進一步求得各葉片的應力分佈、撓度曲線及彈簧剛度。

The rectangular expansion joints formulae of force, moment, equivalent axial movement and spring rate etc under load of axial, lateral and angular movements respectively are deduced. The spring rate formulae and moment formulae of rectangular expansion joints in EJMA standards are complemented and revised.

推導出了矩形膨脹節在軸向、橫向、角向位移下產生的力、力矩、當量軸向位移以及剛度等公式，還對EJMA標準矩形膨脹節的剛度公式及力矩公式作了補充和修正。

A New Model for Determining the Stresses and Spring Rate of Multileaf Spring

求解多片鋼板彈簧剛度與應力的新模型

Study on the Spring Rate of Polytetrafluoroethylene ( PTFE) Bellows

聚四氟乙烯波紋管剛度性能研究

It is pointed out that the changing spring rate of the ring-wave spring should be adapted to the working condition of the compressor valves and it is proved in application.

同時指出其變剛度特性非常適合於壓縮機氣閥的工況條件，並通過實際運用得到證實。

---